VMXNET3 abruptly disconnects from the vDS on a server running Windows 2012 R2
VMXNET3 abruptly disconnects from the vDS on a server running Windows 2012 R2. When this happens, the affected server also loses it's static IP for a 169. address.Any ideas on what could be causing...
View ArticleNo License Icon
Hello,I'm new to VMware setups.I'm trying to obtain and then install a license for ESXi 5.0. I have the trail installed (59 days left) and plan on requesting a license this afternoon. When I go into my...
View ArticleESXI not booting on HP ProLiant G7
I am trying to run VMware ESXi on a brand new HP Proliant DL360 G7. I've made a bootable pendrive with esxi installer. It started booting and I installed the esxi on another flash pendrive (located...
View Articlegetting a error message while installing the esxi
Hi,I am getting a error message "network adaptors were not detected" while installing the esxi5.0 in my laptop, and i cant continue my installation my laptop configuration i3 2nd generation Nic is...
View ArticleVT6105/VT6106S [Rhine-III] No found
Hi All, I hope someone can help me on this regarding one of the NIC card (VT6105/VT6106S) doesn't not detected at vSphere Client. 000:002:00.0 Network controller: Atheros Communications AR8151 v2.0...
View Articleredundant esxi on embedded dual SD
Hello, I've searched around a bit but can't find the answer.What exactly is the benefit from installing a redundant esxi on a single server? My server in question has an embedded dual SD module, where...
View ArticleESXi 5.1 install - server with just two 10g NICs into a network LAG via LACP
Group, We are trying to install a new ESXi 5.1 server with just two NICs attached to a network via a LACP enabled LAG. The issue for us is that the boot option only offer interface, vlan, tag/untagged...
View ArticleESX Nic Card
How many NIC card can be configured on one ESX host and how to connect Virtual switch with a Physical switch.
View ArticleFacing Slowness while installing ESXi 5.1 on server.
Hello, I am facing very slowness while installing the ESXi 5 on my server. could you please suggest what could be the problem.. Thank You!Deepak
View ArticlePSOD while updating ESXi 5.1 to 5.5 on Dell PowerEdge r520
Hello Everyone, we have tried to install ESXi 5.5 on our Dell PowerEdge R520 yesterday.Before we had the possibility to do anything, a PSOD appeared, saying:No place on disk to dump data.No file...
View ArticleESXi ON a laptop
I think this question has been asked before. I installed esxi 5.5 on a desktop and installed vSphere Client on a separate desktop to manage the server and build VM's. The question is if i build a esxi...
View ArticleESXi 5.1 Installation through PXE problems
Hi,I'm trying to install the ESXi 5.1 through PXE but I have some problems. I've read the vsphere 5 documentation about how to install ESXi via PXE linux. I've set up the TFTP and DHCP correctly. In...
View ArticleESX 5.1 config changes do not save
I have two identical servers. http://www.memoryexpress.com/Products/MX39068Both servers have 32GB RAM.Both servers have 3xIntel PRO 1000 NICs, with an on board realtrek NIC.I have identical USB...
View ArticleESXi 5.5 appears to break ANY and ALL on board sata passthrough capabilities
On board sata pass-through capabilities which worked on ALL versions of ESXi 5.1 is no longer working with ESXi 5.5 for Supermicro motherboard: X8SI6-F.Does this mean I have to create my own...
View Articlesystem mirror (raid 1 or?)
If I would like to keep my ESXi (5.5 most likely) and vmstore on a system mirror (e.g., 2x SSDs), what is my best controller option fora) at a minimum 2x6Gb sata ports (with matching bandwidth for...
View ArticleNeed suggestions
Hello Expert,We have some physical servers running with ESXi 5.5 U2. Some configuration changes have been done on those servers by others. We do not want those changes. I was just wondering , do you...
View ArticleCPU 1 locked up. Failed to ack TLB invalidate...
The CPU and memory were upgraded from 4Gb to 12Gb of RAM. It seems to be a hardware issue and cannot be checked using iLO. Another error found is that "no place on disk to dump data."Debugger waiting...
View ArticleEsxi5.1 not recognizing my RAID 10 virtual drive
Hello All, I have a server of cisco ucs 220 m3 and 4 ard drives connected of 1tb each .. with a RAID controller of LSI 92668i... I created RAID 10 virtual drive and when booting it up it shows me that...
View ArticleVT6105/VT6106S [Rhine-III] No found
Hi All, I hope someone can help me on this regarding one of the NIC card (VT6105/VT6106S) doesn't not detected at vSphere Client. 000:002:00.0 Network controller: Atheros Communications AR8151 v2.0...
View ArticleReinstalled ESX 5.1 to upgrade from 4.1 - Disk Extent Issues
Hi... I am having troubles after reinstalling ESX, version 5.1 over 4.1, as a means to upgrade to 5.1, while preserving the datastore. After the reinstall was successfull and I have updated all the...
View Article